Jump to content
The simFlight Network Forums

Throttles well setted but not work in p3d 5.1


Recommended Posts

Hi Pete,
another strange problem has been affecting me since yesterday.
I haven't touched any in prepar3d 5.1 and fsuipc 6 prepar files.

I just updated maddogX to the latest release. Everything ok so far but as of this morning the two engine throttles, even if I open fsuipc are set correctly and I see them move with the correct values, they do not give power to the engines. If I try with a joystick I have an emergency yes.
In the same bodnar card, yokes flaps tillers spoiler axles, brakes and pedals work perfectly.
I also tried to reset the two values I reconfigured them but nothing to do.

Thank you if you can give me an idea on what to investigate.

 

thank a lot

Simone

Link to comment
Share on other sites

41 minutes ago, sisoffi said:

I just updated maddogX to the latest release.

So that was the only change?

41 minutes ago, sisoffi said:

Thank you if you can give me an idea on what to investigate.

Since the only change is the updated aircraft, either that went badly wrong, or it is faulty. Don't they have a website for support?

One remote possibility is that they changed to methods like those used by some PMDG and Aerosoft aircraft -- doing their own interception of the throttle axes so that calibrated values in FSUIPC are bypassing that and being ignored. However, that is a very big change if so. Still really a question for their support, but you could try resetting the calibration in FSUIPC and assigning only to the Axis Throttle Set controls.

Pete

 

Link to comment
Share on other sites

thanks Pete,
yes i only did that update but it works very well.
Strange that they have switched to a specific assignment of the throttles because in fact both with the keyboard and with the joystick the slider makes the throttles move without problems, It is only through fsuipc that it does not. I also tried to reset everything and recalibrate again but nothing to do there is no way they work.

Link to comment
Share on other sites

54 minutes ago, sisoffi said:

It is only through fsuipc that it does not. I also tried to reset everything and recalibrate again but nothing to do there is no way they work

When you calibrate in FSUIPC the way the controls work is different. That's why I suggesting Resetting your calibration  -- i.e pressing the Reset button on the calibration tab, so they are no longer calibrated! And making sure you assigned to the Axis ... controls, not direct to FSUIPC.

Pete

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.