ark1320 Posted July 20, 2021 Report Share Posted July 20, 2021 If a profile specific aircraft section does not have a specified [AXES.xwz] section, does it automatically use the [AXES] specification in the general, non-profile section of the FSUIPC.ini file? Thx, Al Link to comment Share on other sites More sharing options...
John Dowson Posted July 20, 2021 Report Share Posted July 20, 2021 1 hour ago, ark1320 said: If a profile specific aircraft section does not have a specified [AXES.xwz] section, does it automatically use the [AXES] specification in the general, non-profile section of the FSUIPC.ini file? Yes Link to comment Share on other sites More sharing options...
ark1320 Posted July 20, 2021 Author Report Share Posted July 20, 2021 1 hour ago, John Dowson said: Yes Thanks John. Al Link to comment Share on other sites More sharing options...
John Dowson Posted July 20, 2021 Report Share Posted July 20, 2021 No problem. Just remember that by default, all general sections are loaded. Then, if there is a profile, buttons and key sections are loaded and replace/augmented the general sections (i.e. general section assignments apply unless changed in the profile). Axes and calibration sections work differently - if there is an axes profile section, the general section is dropped and the profile axes section is loaded and used exclusively, and the same with the calibration sections. If no profile axes (or calibration) section is present, then the default/general section will be used. Just FYI. John Link to comment Share on other sites More sharing options...
ark1320 Posted July 20, 2021 Author Report Share Posted July 20, 2021 3 hours ago, John Dowson said: No problem. Just remember that by default, all general sections are loaded. Then, if there is a profile, buttons and key sections are loaded and replace/augmented the general sections (i.e. general section assignments apply unless changed in the profile). Axes and calibration sections work differently - if there is an axes profile section, the general section is dropped and the profile axes section is loaded and used exclusively, and the same with the calibration sections. If no profile axes (or calibration) section is present, then the default/general section will be used. Just FYI. John Good info! Thx, Al Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now