pandadoudou

Sorry for the delay Pete. I finally had time to test it out. It worked with the following Axes parameter : Thank you again ! Boris

No probleme Pete ! ... FYI it is on page 45 of your own documentation (which is a pain to write, but even harder when someone tells you to read your own ! hehe) I'll try on these following days, I have another error with the module at FSX startup I need to investigate first... Thank you Boris

So may I try another axis on my wiring board ? Here are the other axis from the .ini file : 0=AX,256,D,1,0,0,0 -{ DIRECT: Aileron }- 1=AY,256,D,2,0,0,0 -{ DIRECT: Elevator }- 2=BX,256,D,7,0,0,0 -{ DIRECT: LeftBrake }- 3=BY,256,D,8,0,0,0 -{ DIRECT: RightBrake }- 4=BR,256,D,3,0,0,0 -{ DIRECT: Rudder }- 5=CX,32,D,6,0,0,0 -{ DIRECT: Mixture }- 6=CY,8,D,4,0,0,0 -{ DIRECT: Throttle }- 7=CZ,8,D,5,0,0,0 -{ DIRECT: PropPitch }- I didn't checked but it seems to have the exact same behavior as before. Boris

So, after some testing, It doesn't seem to make any difference. I also looked at the page 45 of "Advanced users" (37-38 wasn't so helpfull) Here is my axis line inside the FSUIPC4.ini : 8=2U,256,F,M1:9,0,0,0,/326.72,+50 -{ TO SIM: Macro 1_A2A_Comanche: L:Eng1_CarbHeatSwitch set }- May it be because in the UI axis assignment I selected "Send to FS as normal axis" instead of "Send direct to FSUIPC calibration" ? To have the full picture, here is the MCRO line I try to bind this axis to : 9=L:Eng1_CarbHeatSwitch=SET

Thank you Pete, The +50 axis offset is what I'm looking for. I'll be playing with the axis' range via the windows calibration to ensure the full 0-100 range. Boris

Hello everyone, Is it possible, via the FSUIPC UI to convert an output axis value to a percentage ? My axis ranges from -16K to 16K and I need to bind it to a LVar expecting a 0-100 value. I tried to set it as I've done with the throttle/prop/mixture but the result was kinda unexpected (visually the in game throttle just disappeared, woops !... and the behavior was erratic) Thank you in advance, don't hesitate if you need further information. Boris