[FSUIPC 5 won't install]

Hello Thomas

Thanks for your swift reply. I did unzip the file.   I have now solved the problem.  It was my Norton Antivirus software that was putting the executable file into quarantine. I restored this file and FSUIPC5 has now installed.

Thanks again.

Regards

Kevin

 

 

[FSUIPC 5 won't install]

Moved to Main Forum. Please ask questions related to FSUIPC always in Main Forum!

Hello

I hope someone can help.  I have just purchased FSUIPC5 for Prepar3d V4 on a newly built pc.  This PC is a very high specification with Windows 10. I have installed Prepar3d V4  (VERSION 4.2.21.24048). 

I have tried to run the FSUIPC5 installer executable file (with and without administrator) and the following message is returned:  "the app will not run on your pc"

I have run P3D twice (but not completed a flight).  Thought I would use FSUIPC to set up hardware first.

I have run FSUIPC4 on my old pc for many years.

Advice would be welcome.

Thanks

Regards

Kevin

 

 

[Assigning throttle axes- hardware with same axis]

Hi Thomas 

Thank you for your reply.  I now better understand how the Calibration works.  After I posted the comment I progressed with FSUIPC  to assign the throttle axes and it seems to be working using the PMDG 737.  in view of your advice I will now move all calibration assignments to same system, probably FSUIPC as It will offer me more options.

Regards

Kevin

[Assigning throttle axes- hardware with same axis]

Moved to Main Forum, please use for questions related to FSUIPC the main forum otherwise it might not be seen ...

Hello   I would be grateful for your help.  I am just beginning to set up a motorised 737 throttle unit with fsx. When I move the LHS throttle lever on the hardware it shows as X axis and the RHS throttle lever shows as Y axis.   However, these two axes are already in use with my CH Yoke for the elevator and ailerons. I was hoping to leave my yoke calibrated as it is and assign my motorised throttle, throttle levers to alternative axes such as S or T?  At the moment I cannot see the way forward, I have tried using FS and FSUIPC4.  At the moment I have two devices which deliver the same axis reading.  Is it possible to change the axis assigned to the hardware to enable me to move the throttle to axes S and T?

Regards

Kevin