GMB
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Downloads
Posts posted by GMB
-
-
Thanks Pete, that worked a treat. Cheers 👍
-
I am unable to obtain an appropriate setting to operate the throttles in the PMDG DC-6.
I'm using the Honeycomb Bravo throttle quadrant, with the GA setup (dual throttle).
P3d: controls are set to 'disabled', so FSUIPC is the controller.
FSUIPC:
-
Axis Assignment:
-
Throttles 1 & 2 are bound as:
- 'Axis Trottle 1 Set'
- 'Axis Trottle 2 Set'
-
Throttles 3 & 4 are bound as:
- 'Axis Trottle 3 Set'
- 'Axis Trottle 4 Set'.
-
Throttles 1 & 2 are bound as:
-
Joystick Calibration:
- Exclude THROTTLEn_SET is unchecked
- All Throttles are reset - 'Axis not processed'
The above settings are the only way I could control the throttles using the Bravo Throttle Quadrant. However, the control is reversed, and this cannot be changed using the Joystick Calibration settings.
Please advise.
-
Axis Assignment:
FSUIPC has no effect on controls in the Sim
in FSUIPC7 MSFS
Posted
FSUIPC shows connected (Connect is greyed out)
Controls are set up and calibrated, yet the sim controls the actions. As with P3D, the direction was to disbale controls in the sim, so FSUIPC could take over - I loaded profiles with all actions deleted - empty. This had no effect, FSUIPC established control actions were not seen in the sim.
I am using Honeycomb Alpha and Bravo.
I am unable to get this to work with any aircaft in the sim.
Moving the controls moves scales inside FSUIPC, but this is not replicated in the sim. Switches and buttons are the same.
Please advise.
FSUIPC7.log FSUIPC7.ini