razzle
-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Downloads
Posts posted by razzle
-
-
I have a registered version of FSUIPC. Is it possible to assign employment of spoilers to an axis rather than a button. I have the new Saitek joystick and TQ. I am sure I was able to with my old CH Yoke but I cannot rememebr how.
Thanks
Renzo
-
I have purchased WideFS for FS9 and manage to get it working in relation to Active Sky (ie, AS2004 working on my laptop, FS9 working on my PC) but I am problems with Squawkbox on my laptop which gives the following error message:
Squawkbox unable to load aircraft database information.....etc..Squawkbox will not start.
Any advice.
Regards
Renzo Nicoletti
-
Thanks Pete but I have just found out the answer, 'autorudder' under plane realism in FS9 set-up menu.
Regards
Renzo
-
I fly PMDG 737 and 747 and would like my CH Yoke (x axis) to control steering whilst on the ground and spoilers whilst in the air.
This used to work before I had to do a re-installation (I never configured that way so don't know how) but now it doesn't.
Would my registered version of FSUIPC help or do I do something in FS9 assignments or is it a PMDG issue?
I am techinically challenged so any advice would be appreciated.
Renzo
-
I have recetly purchased a CH Yoke and would like to use lever 1 as gear up/down and lever 3 as thrust with a reverse thrust capabilty.
I know that both these aspirations are possible with the use of FSUIPC but I cannot figure how. Yes, I have read the manual (too clever for me) and yes I have searched this forum for relevant advice (which I have found and I cannot undertand it - too clever for me too)
So finally, I downloaded CH Manager and guess what, I cannot understand that program either.
So if anyone has an idiots' step by step guide to help me, I would appreciate it. My email address is below as well.
Thanks
-
I have solved my problem. I had 'flightplan waypoints only' ticked in my options. Slightly embarassed!
-
Well, I am referring to the display on the map and on my version, the VOR's do not appear at any magification unless they are part of a flight plan.
eg. ANT (VOR Antwerp), does not show up on the map unless I put it in my flight plan and then all the details appear, depending upon magnification as you say.
If that this is different for you then there must be a problem with my installation.
Thanks for the feedback.
-
I have noticed that I can only see VOR information on VOR's which are part of my flight plan. Is there any way to make all VOR's visible, whether or not they are part of my flight plan.
I have tried clicking on the VOR button on the tool bar but this doesn't have the desired result.
Thanks
Razzle
Spoilers and Joystick Axis
in FSUIPC Support Pete Dowson Modules
Posted
Thanks Pete for prompt response.