RMM

Thanks Pete... My first post referenced the Yoko yoke and P3d v 4.3 . That means I use FSUIPC5. The assignments are only Ailerons X axis and Elevator Y axis. No key assignments for the Yoke were input. All assignments in P3D were deleted. I was quite surprised to find the Slope Curve was not showing. Odd. BUT for now, please don't take up your valuable time. Let me try again. The yoke is working properly under P3D calibration now. But I do believe that I can get a bit better handling via FSUIPC5. I will come back if the problem recurs. thanks much! RMM

Hello Pete.. Will do as you suggest. But...Leaves this question unaddressed.... Why was the Slope Curve box blank? RMM

Hello.. If you are setting assignments for a YOKO yoke, please send me a PM. BEST scenario would be if you also fly any A2A Accu-Sim aircraft. I fly the A2A C172 in P3D v4.3 Would like to talk about the set up process you went through. thanks RMM - Guam

Hello.. My initial experience with registered FSUIPC did not go well. My device is a Yoko yoke. After setting the axis assignments, I went to the calibration screen. I was following a tutorial video for a joystick. The middle SET figure became the same at the left and right settings. Also the Slope Curve was not visible. I tried reinstalling, but same effect. I disabled FSUIPC and went over to P3D v4.3 calibration. Did not take screen shots. Sorry. Any initial thoughts? RMM - Guam