gcmoir
-
Posts
4 -
Joined
-
Last visited
gcmoir's Achievements
-
Hi John, Many thanks for your reply. I had already tried with ServerName and ServerIPAddr with no luck but for some reason I had not tried using Protocol. When I used Protocol and ServerName it made the connection. Thanks for your help, I was really tearing my hair out on this one. Best, Graeme
-
I have been using Windows 10 with P3DV4.5 and FSUIPC with WideFS for a few years with no issues at all. I have just upgraded both my computers to Windows 11. Everything seems to run fine on both computers except for WideFS will not connect to the server on the other computer. Both computers are on the same Workgroup, both connected to the same wireless network using fixed addresses and I can ping each computer. FSUIPC and Wideserver are both registered. I am using the latest version - 6.2.1. I have uninstalled and reinstalled a couple of times with no success. Firewall is not active and turning off antivirus makes no difference. I am running P3D and FSUIPC as Administrator. I have also tried with FSUIPC on the C drive and on my E drive. I cannot see any obvious reason for this problem so really appreciate if anyone can help. Thanks, Graeme FSUIPC6.ini FSUIPC6.log InstallFSUIPC6.log WideServer.log WideClient.log
-
Setting up Reverse Thrust on PMDG B737
gcmoir replied to gcmoir's topic in FSUIPC Support Pete Dowson Modules
Hi Pete, Many thanks for the reply. I will follow up on your suggestions. Graeme -
Windows 10, P3D V4, PMDG B737NGXu, Latest version FSUIPC registered. Apologies if this has been covered before and I'm sure it has but I cannot find directly related info. I have Saitek throttle quadrant which works perfectly for controlling the individual throttles. I have just built a new throttle quadrant which will still use the Saitek unit for the throttles but now has separate levers and pots for the reverse thrust. How do I configure these reverse thrust pots to be active through FSUIPC and still maintain the Saitek throttles setup and calibrated within P3D. I have been trying to do this following the axis assignment and joystick calibration instructions but just can’t get it to work. I can get the reversers to move but I lose control of the throttles. Thanks for any guidance.