RockH

Will give that a try. Thank you so much, John!

Hi John, turned out that these buttons are above 32, so I was able to get them to work with the Lua script that you mentioned. Thank you very much for your guidance. I have another question I hope you can point me in the right direction - now that these knobs work but I had to roll 2-3 detente for it to register as 1 press, is there an option to increase the “sensitivity” or do you think it’s a hardware limitation?

Hi John, Thank you for your response. If you are familiar with the x52 Hotas, under the mdf display on the throttle side, there are two knobs on the two sides and two buttons at the center and non of these are recognized by fsuipc. At first I thought that it’s a hardware problem, so I test them in windows and they all functioned. Normally, in fsuipc, I just press the buttons or turn the knobs and then fsuipc would recognize them and I just assigned functions to them. I’ve successfully assigned all buttons and even the mouse wheel on the throttle through fsuipc. I will Dig around some for and look at the Kia script that you suggested. Thank you, Rock

My apology if this has been asked before but I’m trying to program the 2 rotaries on the saitek x52 pro MFD panel to control speed and altitude, however, fsuipc does not recognize these knobs. Is this a known deficiency or am I missing something?