Jump to content
The simFlight Network Forums

TerribleAviator

Members
  • Posts

    23
  • Joined

  • Last visited

Everything posted by TerribleAviator

  1. :idea: Just thought of this: is it possible in FSUIPC to - for example - assign the throttle axis to the Saitek throttle and to a lever on the GoFlight throttle quadrant at the SAME time? Sorry for all the questions: this is new territory for me... Maybe I just want the impossible to be possible... If so, let me know. :lol:
  2. Pete, (without the R, sorry!), Thank you for your quick response. All the USB hubs are powered, but i will check the power management you mentioned. Good point, have not thought of that and it could explain a lot. When I start FSX, some USB could just come alive and FSX starts reassigning. Preferably I would like to use all the controllers in the same FSX session, all at once that is. Sometimes I fly a fighter jet with the stick and 5 minutes later I am in the mood for some general aviation with the yoke. Sometimes I use the single throttle of the Saitek, but with multi-engine aircraft I use the GoFlight throttle and so on... I have read the passage above three times now, and I am still not sure. Just to see if I am correct: is it possible to disable ALL controllers in FSX, clear ALL the relevant controller assignments in FSX and assign all axis and buttons of all the connected controllers using FSUIPC? If so, that would be great. Or am I overlooking something here?
  3. Peter and others, please help me out. (please read the whole post, questions about FSUIPC are in the last part) Here goes: I have a FSX setup containing the following: Saitek yoke (yoke and throttle) Logitech G940 Flight System (stick, throttle and rudder pedals) A full GoFlight set (radios, several switches and a TQ6 throttle quadrant) I currently use the proprietary GoFlight software to configure the controls externally. Therefore i must delete ALL the axis and button assignments within FSX. So far, so good. I have assigned the axis of the Logitech and Saitek units using the built in FSX controls configurations within the FSX settings section. It all works like a charm, BUT... after a while the controller config becomes messed up. It seems - for some reason - FSX redetects the hardware and automatically reassigns some buttons and axis. The most troublesome is the reassigning of the GoFlight throttle quadrant. FSX assigns some levers to ailerons and rudder and i must delete these assignents manually over and over again. Same happens to the Saitek yoke. After a while a button is automatically (re)assigned to the landing gear on the Saitek yoke and this disables my landing gear lever functionality in the GoFlight setup. (looks like GoFlight does not agree with a function being double assigned) I figure it has something to do with the use of several USB hubs (i use lots of hardware peripherals). Maybe the hubs sometimes change the ID's of the ports and FSX 'thinks' there are new devices connected. Does that make any sense? Anyway, here is my question: is there an easy way to disable (re)detection of controllers and / or reassigning controls? Or... is there a way to make the control config file read only or something? Or can change a setting somewhere so all the assigned controls remain the same? And yes, I have thought of buying FSUIPC and assigning controls through this program. Does FSUIPC overwrite the standard FSX settings? If so, it will probably work. Do I then manually have to clear all the assignments or does FSUIPC take care of that? In other words: will FSUIPC make my life easy and headache free? Is this the solution? So many questions, it drives me nuts. All the input on this is very much appreciated.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.