ribitt

It's only two lines. Will this help? [Axes] 0=0Y,256,D,8,0,0,0 1=1Z,256,F,65697,0,0,0 Ribitt

Thank you Pete. That did the trick. I deleted the INI file and when it re-built, everything was back to normal. I could end you the corrupt file if it would be of any forensic use to you. Regards Ribitt

Thanks for your prompt reply. I had already reviewed every assignment and there is nothing amiss. Another factor. I disconnected the joystick (shift + K). Nothing worked of course, but I looked then at the FSUIPC brake axis and the numbers there still moved with the elevator axis control. It's starting top look to me like a defective joystick. I will go now the the Saitek forum and see what thet have to say. Thanks for your help Ribitt

I have deleoped a strange confl;ict betwee FSUIPC and an X52 joystick. When the elevator axis is used, it also sets the right differential brake. When I look at the FSUIPC brake axis, the in/out numbers on the right brake go up and down with the e;ecators and are 0 when the elevator axis is centreed. The elevators operate normally. My Saitek pedals with the brake axes have been umpugged. All other FSUIPC and Sautek functions are normal. I have the latest drivers from both Saitek and FSUIPC. FSX with acceleration. Win 7/32. Any comments? Thanks. Ribitt

I am having extreme difficulty following some of the calibration instructions on pages 40/41 of the 4.26 manual. "Edit the FS Cfg file etc." I can't locate the [Controls] section. A search of FSX brings up nothing. "Disable the joystick input in FS in Options - Controls" When I do that I have no control whatsover. I would appreciiate any advice. Thanks. Ribitt