h512243512
-
Posts
4 -
Joined
-
Last visited
h512243512's Achievements
-
i just sovled problem by sending direct to calibration and then i calibrate it it is weird , it should be working when i choose to send to fs as normal axis
-
fenix320 is the plane that i use it worked once this morning but after that it is not working again
-
intially the center point is like this after i customize center in calibration, it should be like this and itacually did in older version but for this version the center of my yoke still like this i want the center is a bit shifted to the right for training purpose. any ideas ?
-
i just assign my yoke to aileron axis through fsuipc 7.4.11 but when i go to axis calibration setting up my center poin it doesn't work, in the past version it worked i could set whatever center point i want but this time whatever center point i set it just stay the same position