Hi Pete,
How do I find out if my Saitek Yoke and throttles are set to digital vs. analogue (and how do I change these settings)? I have been having a terrible time getting this new equipment to work.
I calibrated in Windows and assigned in FS then calibrated in FSUIPC. When in the latter the throttle 1 lever 2 jumps directly from 0 to 16383 (it shows this in both axis tab and calibration page). Throttle 2 levers 1 and 2 goe to 16383 max and 0 at idle (In and Out).
When using any Aircraft, I throttle up and it spins up but the more I input throttle the engine decreases back to idle (at full throttle).
I had no problems with CH equipment and have nothing but frustration with Saitek. I haven't even gotten to the point of random button firing as I have been reading about.
One last comment - when I began to assign buttons earlier in the day, I realized that the FS9 Config file could be causing problems from older settings so I allowed FS to create a new one and started the whole process over again.
Thanks for your assistance.
Ted "Triple Three"
AAL333