Hello Peter,
I'm experiencing an issue that I cannot figure out and thought maybe you can help me out on. I built a B737 sim using PM Software, for MCP I'm using CPFlight hardware with latest updates. For the throttle quadrant hardware I'm using Dragonet's hardware (http://www.symulatory.com/english/produrottle.htm).
After engaging or disengaging the A/Ts, one of the throttle levers becomes inoperative and the other lever takes on the task of both engines. The inop lever gets forced by the servos to idle position and does not move from there (unless you physically hold it with your hand, and if you let go it returns to idle). Sometimes this behavior starts even if the A/Ts are not used. Sometimes the bad throttle is the left one sometimes the right. I have not been able to accuratly reproduce it, it does it whenever it feels like it, believe it or not, hehe.
I have checked with PM software and they seem to think the trouble is with the TQ's controller card and/or driver. I'm not sure if the card and driver is to blame because I've been talking to a gentleman from Germany running the same TQ but with a different card and driver and is experiencing the same exact issue, he even has the same MCP and setup (Just in case it makes a difference).
I was looking around the FSUIPC module and noticed some throttle settings, not sure if maybe they should be set differently or changed in any way.
I'm really at a loss as to what to do here, I hope that maybe you have some ideas of what can be done, your help and comments will be GREATLY appreciated.
In advance THANK YOU!
Alex
