Hello, i am quite new to the world of fsuipc and i have v4.52 registered and installed. i have 1 bu0836x card for a small overhead and all buttons are interfaced thru' fsuipc, the same goes for my ch throttle quadrant, joysticks disabled in fsx and working fine thru' fsuipc. now comes the strange part... i also use a saitek flight yoke (without the throttle) and had a few problems with phantom key presses. So i deleted every key and button assignment in fsx and fsuipc associated with the flight yoke, then just assigned my elevator and aileron axis for it thru' fsuipc. When adding a few more toggle switches from my ovh and bu0836x card i used the normal procedure but noticed when i switched the new button to assign it, my saitek yoke had been assigned a number of actions like landing lights etc.. i know for sure i didnt assign them??? then as im about to assign a function for my new switch from the fs dropdown within fsuipc the assignment changes by itself from joystick 0 button ? (the bu0836x card) to the joystick number 2 ( assigned to saitek yoke) and i find again 2 or 3 fresh button assignments linked to the yoke. I can replace the yoke if its faulty but i cant understand fsuipc assigning buttons by itself.... i cant see how?? sorry for the long winded post and lack of paragraphs im on my laptop and the return key wont work lol thankyou for your time regards steve