Jump to content
The simFlight Network Forums

GPI Steve

Members
  • Posts

    6
  • Joined

  • Last visited

Everything posted by GPI Steve

  1. Ok Thanks Pete for the speedy response, I'll look into the voice recogtion addons and maybe i should post this in the correct rc forums.
  2. I installed radar contact 4 today and it has given me nothing but problems, I have fs9 and fsuipc v3.9. I have a hardware cockpit consisting of various opencockpits and goflight modules. I fly pmdg 737 exclusively. When i try to program vr insight cdu it conflicts with rc4 as if sending keyboard commands. With o/cockpits mcp and efis certain dials and switches are either causing conflict the same as cdu or not workinfg at all. As soon as i stop rc4 and reload fs9 everything is fine and all works as it should. I know it has to do with the keyboard commands conflicting with each other but im afraid i have that much stuff installed and working through fsuipc that each time i have tried to give radar contact a different key assignment for the various commands i just cause something else to act strange. How can i re-assign the 8 or so keyboard commands in radar contact and be sure im not using an already in use key combination. Is there a way to do it ? TIA for your help. Steve A
  3. Hello peter, can you tell me if its possible to have a few of my goflight modules operate from a secondary networked pc using widefs, as i have no more spare usb inputs on the main flight sim computer? Thanks Steve
  4. ok i am at my sim computer now so i can type properly lol. I inserted the line " Eliminate Transients = Yes " into the INI file and after a couple of hours i can report no more issues, Thankyou. My other buttons dont seem to need to be pressed for any longer than normal so hopefully this is the issue fixed. As long as i understood the instructions correctly from the advanced user pdf that is :? as im not brilliant with a computer. Hopefully everything will be good now. Thanks again for your time Steve
  5. Thankyou for the speedy response pete. I shall update and take a look at eliminate transients this morning and post back my results.
  6. Hello, i am quite new to the world of fsuipc and i have v4.52 registered and installed. i have 1 bu0836x card for a small overhead and all buttons are interfaced thru' fsuipc, the same goes for my ch throttle quadrant, joysticks disabled in fsx and working fine thru' fsuipc. now comes the strange part... i also use a saitek flight yoke (without the throttle) and had a few problems with phantom key presses. So i deleted every key and button assignment in fsx and fsuipc associated with the flight yoke, then just assigned my elevator and aileron axis for it thru' fsuipc. When adding a few more toggle switches from my ovh and bu0836x card i used the normal procedure but noticed when i switched the new button to assign it, my saitek yoke had been assigned a number of actions like landing lights etc.. i know for sure i didnt assign them??? then as im about to assign a function for my new switch from the fs dropdown within fsuipc the assignment changes by itself from joystick 0 button ? (the bu0836x card) to the joystick number 2 ( assigned to saitek yoke) and i find again 2 or 3 fresh button assignments linked to the yoke. I can replace the yoke if its faulty but i cant understand fsuipc assigning buttons by itself.... i cant see how?? sorry for the long winded post and lack of paragraphs im on my laptop and the return key wont work lol thankyou for your time regards steve
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.