Chaptain
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Downloads
Posts posted by Chaptain
-
-
Thanks for the quick reply. Point taken, there isn't much ancillary information there :-/, it's FSUIPC 3.99 on FS9.1.
For some reason the classic spoiler lever config didn't arm the spoilers the way it's meant to. But I might've had the detente set too to short a range. I'll try again and report back.
Just to explain the second bit there again: The way I configured the lever to get around my problem, the entire range is assigned to the spoiler axis. So even though the lever is in the 'armed' range, it is also in the 'spoilers up' position on the axis.
Cheers,
Stefan
-
Hi everybody,
I've been fiddling with the spoiler lever on a 737 for a while, trying to combine the arm/disarm switch with the position lever. I basically created the following:
- two equal short ranges at the very top (16384-16000), one of them switching off the spoilers, the other one disarming them.
- one short range adjacent to that (16000-13840) arming the autospoiler
- the entire lever (which is defined as the spoiler axis from -16383-13700)
The problem is that the autospoiler does not extend on touchdown, as obviously the lever is quite close to the retracted position when in the 'armed' range. If, however, I insert something like *0.9,-2560 to block the upper part of the range, the arm and disarm ranges end up being deactivated as well.
Anyone any ideas for ways around this?
Cheers,
Stefan
Axis Repeat Rate
in FSUIPC Support Pete Dowson Modules
Posted
Hi guys,
just re-installed Flight Sim, decided to make a few changes to my control setup and am now lost on two issues:
Can I assign button repeat rates to each button separately?
How do I change the repeat rate for a range button press on an axis?
Thanks a million,
Stefan