Sirxamoc

Sorry, when I said axis number I should say that the axis that I was trying to set, the values in window next to the Delta under Raw that have in out are pretty much the same. there is no great variance. I may have to scrap trying to have FSX and PREPAR3D on the same machine. As this may be the major source of my issues. Thanks for the quick response.

Pete, I have been working with your products for quite a while and normally can find the answer by just looking but I am stumped at then moment. First I have Prepar3D installed. I have a full Saitek control system that I want to use with FSUIPC. today when I started the identifing and calibration I noticed that the very first control I tried to set just stayed in one position, As I checked I found that the AXIS number stay the same. If I move the lever to full I get a 16383 IN and a 16256 OUT, when I move the lever full down I get a - 16384 IN/OUT. This is also with send direct to calibration. When I go over to Calibration I get no response to that lever that was set. I am running your latest 4828 upfdate. If FSUIPC sees the lever moving can I assume that communication is established between PREPAR3D and FSUIPC? If not is there a way I can test it. When I set the buttons I am having no issues. It is the AXIS that are not reading correctly. I sure it is something that I have not done correctly but there is little info out there right now to help. Thank you for supporting PREPAR3D I think it has the potential to be what FSX could have been.