gilby

Pete, My print board of my PFC rudder pedals ware defect, so a friend of my repair the printboard via a soft ware program called ARDUINO. When i like to assign the axis of the rudder pedals in my FSUIPC5 (register) , i assign f.e the left brake axis, afterwards when i assign my rudder axis, FSUIPC5 shows my every time that the axis is already assigned for the left break, so i have to clear the axis over an over again to get it assigned as the rudder axis.The same f.e if i like to assign the right brake axis, FSUIPC5 says its already assigned for the rudder axis, so again i have to delete the axis , re scan etc many times before it accept the right brake axis. I order now a new PFC print board because i suppose the "Arduino" software giving my this problems.... So i let you know when i have the PFC print board if Arduino was the problem. Once again sorry for sending you my problems , but i like to thank you for your support and reply . I am a 62 year "old " man from Belgium, so sorry also for my poor English and that i not have a very good good knowledge about computers! Also thanks for the great work you are doing for flight simmers via FSUIPC. Kind regards, Gilbert.

Hi Pete, Thanks for the info, here by the files Gilbert. fsuipc5.zip

Hello Pete, Thanks for your reply and support, The Vjoy is my boeing 737 motorized throttle from cokpitsforyou for PMDG 737-800. The Arduino is a software a friend of my installed on my PFC rudder pedals because the original print board was defect, maybe the Arduino software give me the conflict problems? I tried to send you al the log files you asked me , bud i can not attach them because the size is to big, can i send the files via WE TRANSFER to you? Once again i am very sorry to send you al my problems! Kind regards, Gilbert.

Sorry to disturb you with my problem and my poor English writing. I have P3DV3 on my F/ disk, so my new P3DV4 is also installed on my F/ disk. I bought FSUIPC5 , and now i have conflict problems with my axis of my PFC yoke en rudder. I deleted al the axis in P3DV4, and i have stil the problem.I also deleted the FSUIPC.INI file of P3DV3 bud no results. Wat could be the problem? I was already surcharging on the forum etc bud could not find a solution. Kind regards. Gilbert. FSUIPC5.log

Hello, I have the following problem, i am using Windows 7, FSX, i installed my cirrus boeing 737 yoke when i start up fsx the yoke in al the airplanes also in the PMDG737NGX is shaking and shivering! When i remove the FSUIPC.DLL then i dont have this problem, i have the latest registrated version of Fsuip. Can somone can give me a tip, Sorry for my poor English writing. Gilby.