Salbado

FSUIPC is still pretty magical... Thanks for such a great program that has made my homebuilt come to reality... Regards

Peter, Thank you on the ECAM EICAS solution and guidance, it worked like an absloute charm. Now, that I am starting to understand this, can I set up a KeySend with a key press using 3 key presses such as ... CTRL - Backslash (\) - E The codes are obviously 10 , 220 and 69 but...FSUIPC will not allow me more than 1 key selction and 1 state selection in the on-line set up. Can I modify for more than 1 key in the .ini? I fI cna do this I can communciate with multiple programs like FDS Flight Deck Companion for sounds whilst exectuing Project Magenta commands. Again, Thans

Thank you again, Peter I think I am all set...

Peter, Thanks again and I understand your instruction... I have carefully studied the Wide FS documentation and have determined that the following should work...could you just confirm my use of TAB? I am bit confused if should be a value of 12 or 4 or something else??? I am using the value 10 for CTRL (shift state) and I am using Run1 to fire up PM Engine Page. Here goes... CLIENT COMPUTER ActionKeys=Y KeySend1=TAB,10,Run1....what value for TAB? SERVER COMPUTER KeySend1=15 (15 assumes the button number chosen by FSUIPC when asked to press the button on the joystick) I think this will work...

Peter, Thank you for your quick response and I do hope you are feeling well after your surgery. I think I will try and get a button programmed first in FSUIPC, and then go into the cfg and make a manual change to the entry. How would I code the button command to go the PM Window - Engine (Client B) and key pulse a CTRL TAB? I will be crossing the network and need to identify the particular client (is this the window name feature?). Regards.

I am running Project Magenta ECAM on a dedicated computer in a 5 computer network and I would like to assign a Joystick Button to cycle through the EICAS pages (Bleed, F.CTRL, APU, etc.). The keypress required by the Project Magenta program to cycle through (F7 Function (Dual -Upper & Lowere Engine) of th ABGC is CTRL+TAB. I have tried to use the EICAS increment and decrement PM control in FSUIPC to no avail although the Pages increment and decrement work in the F3 Function (Engine Page -Single) quite well. However I need to cycle in the F7 Function which provides for a dual upper & lower display set-up. I am reasonably sure that this can be done by FSUIPC but I am not sure how to do it. Regards