MSS

Thanks Pete :D Regards Jean

Hi Pete Yes i Bought PM systems,and i think you are correct in saying it might be in the target software that i have to configure .As i dont have any knowledge about programming or how to set it up,i hope there is someone out there that might help me a bit Thanks Jean

Hi Pete This board has been programmed already with all the FSUIPC codes and Project Magenta codes using their own TRC code for example: Table of input/output poss. based on PM codes TRC # Description FSUIPC# 1048 Cutoff1/CutoffL 561A 1048 Cutoff2/CutoffR 561A 1144 Taxilight 5643 Then there r input/output poss based on FSUIPC codes 186 Strobes 0D0C 181 Pitot heat switch 029C Now in the software for the Multicontroller you just put in the TRC# and the description comes up (as above) you save and when you activate the switch connected to 186 for example the stobes come on.As i said for the latter example those codes work(MSFS),but when i program any Magenta codes as per first example,i cant get any of those codes to work I hope this is a better explanation Jean

Hi i recently purchased simkits multicontroller to connect my switches to operate pmsystems.However i have a problem in getting some stuff to work. I have network computors and i run Magenta software.I have GC,MCP and PM systems.All works well.I have installed the multicontrollers and they are configured,it was easy.When i program the boards with the table of i/o possibilities on FSUIPC codes i dont have a problem.but if i try the the i/o possibilites on Project Magenta codes,nothing works that i put in.My PM software communicates with FS ,FSUIPC and WIDEFS is running without problems.For instance if i put the code in trc# 1047 which says Cutoff1/CutoffL,it doesnt cut of the engine.I dont have a problem with FSUIPC codes ,only with PM codes Can anyone help me,surely pmsystems should have picked it up if FSUIPC broadcasts the code,or is there another setting somewhere? :roll:

Hi Pete Forgive my ignorance,so what youre saying is whatever i program as an offset in FSUIPC,should affect or apply to all of the clients ,if i have Widefs installed.Is that it?

Hi Pete Its true that the offsets can be programmed via FSUIPC,but its for the server.If all my add ons are running on different computors using Widefs,i cannot use the drop down list in FSUIPC.How would i then send a command to trigger an offset in a client on a network? Regards Jean

:oops:I am a NB to all this programming and info thats available.Frankly everything just confuses me. I can program offsets for my buttons in FSUIPC,but i dont know how to program Magenta offsets for glass cockpit on a client. Do i use the keysend facility in FSUIPC ?,and what is the format then in the wideclient.ini when the keysend had been received by the client. Hope someone out there can help