CNicholson

Hi Pete, Thanks for your time and the DLL file. I'll keep working on the problem and if I find the answer, I'll get back to you. Regards, Chuck

Hi Pete, Your observation is correct. I did receive the Windows popup requesting I direct it to fsx.exe. As soon as I did and then clicked on Open the Installer warning message appeared. I checked the registry location and the setup path correctly addresses E:\Flight Simulator X. I have not added any new hardware. I have added some FSX software including Capt Sim's B757 for FSX and FS Genesis Mesh. I have also applied some of the lesser complicated tweaks to see if my fps would improve around the larger airports annd cities. I also read somewhere that removing the modules folder was a requirement and I tried that but it made no difference. There is one other software change that I believe may have been made after I initially installed FSUIPC 4.02 but before I registered it. That was to change Internet Explorer from v6 to v7. If we cannot get the Installer to correctly recognize the proper path, is it possible to download v4.03 without the Installer? Regards, Chuck

Hi Pete, I have FSX Deluxe activated and installed on my E Drive and am using Windows XP Pro with SP2. I also have FSUIPC 4.02 installed, registered and working. When I tried to install v4.03 I got the following Installer errors: Warning: This installation attempt will proceed, but note that your FSX installation is not correctly registered in Windows. This may well cause you problems. Clicked OK and then got: Problem! Cannot place FSUIPC4.dll into FSX\Modules folder. Please check for Read Only/Attributes. I have looked for applicable files marked Read Only without success. I have also checked the Registry and every location where FSX is recorded with a path it shows E:\Flight Simulator X Can you help? Regards, Chuck (CYOW)