Key for panel

[peet66]

I have downloaded the airbus A318, it's an exe file.

I also have the latest fuipc 3.47

For finishing the Airbus setup I have to add this key:

A320.gau - key: VSB5 4OK5 UVWN

HOW DO I DO THAT????

Paul

[flypfc]

Programs with appropriate credentials will run with an unregistered copy of FSUIPC provided that they are provided with an Access Key. If the key is automatically provided to FSUIPC when the programs run, then you do not need to be at all concerned. However, in some cases (hopefully very few), a manual method of entering the Key for a program is provided. This is accessed via the Register an application program button, and the details are entered into a dialogue box, as shown on the right. The details to be entered will be supplied by the program author or its suppliers, probably in the documentation or in a “read me” file. Once this is done and accepted, the relevant program can be run without restarting FS—but if that program is already running it will have to be restarted

[peet66]

--COMPLETING THE PANEL INSTALLATION (Base Pack Only)

*** You must download and install (if you haven't already) Peter Dowson's FSUIPC module for FS2004 (available from: http://www.schiratti.com/dowson.html ), and register Eric's panel with the following key:

A320.gau - key: VSB5 4OK5 UVWN

that's what the textfile says. I do have the unregistered version, but I don't knwo where to put the key!!

[flypfc]

With FSUIPC.DLL correctly installed, and Flight Simulator running and ready, look at the Menu. (Press ALT to bring it up if it is hidden). There should be a “Modules” item, probably the vary last word at the right-hand end of the menu. Select it. You should then see “FSUIPC …”. If you don’t, press ESC to get out of the menu, wait a few seconds, and then try again. If you still don’t see it, then either you have not installed FSUIPC.DLL correctly or there is an older version running

after you open FSUIPC click on the

"Register an application program" button, and the details can be entered into a dialogue box

Once this is done and accepted, the relevant program can be run without restarting FS—but if that program is already running it will have to be restarted