pgarino Posted February 19, 2017 Report Share Posted February 19, 2017 Just purchased KORD add-on for TRACON 2012. A few things: None of the center frequencies provided work for departure hand-offs from KORD. Also, after copying, as instructed, the sidstar_ord.txt contents into sidstar.cfg.txt none of the traffic appears, so I go back to using the original sidstar_cfg.txt. With regard to the center frequencies, are you required to enter 3 decimals (i.e., 126.325 for Ft. Wayne) or just two (126.32). Thanks, in advance, for your help! Peter Windows 8, 64 bit Link to comment Share on other sites More sharing options...
mc16v Posted February 20, 2017 Report Share Posted February 20, 2017 Try re-installing, it's not an issue thats been mentioned before. just a note, make sure the sidstar_ord contents is added below the existing contents of the original sidstar_cfg, do not delete the original contents. Most of your area of control falls under the "central" centre sector so most of your handoffs, if not all, will go to the same frequency. You'll have to enlarge your area of control in the editor so it overlaps the ring of outer sectors, this will allow the aircraft to travel into a new sector before you hand it off giving you more variety. Link to comment Share on other sites More sharing options...
pgarino Posted February 20, 2017 Author Report Share Posted February 20, 2017 Thank you MC16V for your help. That worked. I also needed to use 3 decimals in the freq. Appreciate your help! PG Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now