Jump to content
The simFlight Network Forums

TszChun.Anson

Members
  • Posts

    30
  • Joined

  • Last visited

Everything posted by TszChun.Anson

  1. I always assigned axes for my joystick and throttle in FSUIPC’s “axis assignment” page. Supposedly once I move any of the axes, there should be a number/parameter shown in some boxes in that page, and then I assign an action for that axis. However, there is no number/parameter shown when I move the new yoke (i.e. the movements of the axes of the yoke are not detected at all). Thanks very much! Anson
  2. Thanks for your reply. Sorry I forgot to mention that the yoke is identified as "Plasma-MM2", that means your guess was right. Actually if I do the calibration in P3D controller setting page, the yoke can function properly. But back to FSUIPC, the axes cannot be detected unless I check "enable controller" in P3D. I wonder if FSUIPC to some extent "links" to P3D to acquire some controller information... However I still prefer to calibrate the yoke via FSUIPC because this is what I have done for my throttle and joystick. What can I do so that I can calibrate it via FSUIPC? Anson
  3. Dear Pete, Greetings! I just purchased a new yoke from ACE which requires no driver. I guess since there is no driver but just plug and play, the axes need to be calibrated either by Windows controller setting or P3D or others, otherwise their movements cannot be properly detected. Now I want to do the calibration via FSUIPC. However, all the movements of the yoke cannot be detected in FSUIPC's "axis assignment" page when I move the yoke (no number/parameter is shown in the interface). Then, in FSUIPC's "joystick calibration" page, with "enable controller" option enabled in P3D setting page, the numbers in the box "in" and "out" did change but with delay (e.g. when the yoke is already physically centred to neutral position from full left/right, the number is still changing and after a few seconds stop at 0). However, with "enable controller" option disabled in P3D setting page, the number stays at 0 and will not change even if I move the yoke. I would be thankful if you could help! My log and Joyscan file are attached. Thanks very much! Anson FSUIPC5.log FSUIPC5.JoyScan.csv
  4. Dear Pete, Greetings! I am writing to consult about the issue of FSUIPC. Having got the Windows 10, P3D and FSUIPC 5.123 clean installed, every time I start my sim there will be a pop-up message "Cannot operate! Something wrong with SimConnect library...Memory problems detected! Operations restricted". The log has been attached to this post. That contains a error message: 1063 Exception 5 "VERSION_MISMATCH", Ref 1, Version 1.0: Open: SimConnect Version incorrect! I would be thankful if you could help. Thanks so much! Anson FSUIPC5.log
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.