Blaster254

And no I didnt want to do this but always have done. Oopsie! On it. One last Question. Should I delete the profiles in the INI and start fresh? It wont take long if i have to

Thank you so much. That makes sense. I assume by creating multiple profiles they are possibly conflicting? FSUIPC6.log

Here's the ini file. What i meant by another is when i copy the settings to another PMDG 747. Thank you for looking at this. Much appreciated. Will forward a log file as soon as one is compiled. Kind regards Ryan FSUIPC6.ini

John, apologies. I was a little rushed. Will upload today

If this has been asked before, my apologies and please point me in the right direction. mad simole as I can put it. PMDG 747. I have the saitek yoke and additional throttles. All four engines are assigned. Reversers in the buttons settings. The issue is whenever copying setting for another 747 or starting a new flight. Throttle 4 is the culprit. The calibration is out and automatically has reversers set even at idle. If I try to use the calibration page, it gives up completely. Now the interesting thing is that after landing, harmony is once again restored and it works fine. I’ve had this issue for ages. Tried to figure it out. I cannot. If I could get some help please Ryan

Pete, Apologies but I appear to have it working. No idea how. But its running better than any of the sim settings ever did. Thank you and apologies again. Time to do some You Tube searching and reading I think. Ryan

No. Throttle 4 is the only throttle not moving in the sim itself. Here's the attached INI file. FSUIPC6.ini

Thanks Pete. Apologies, I meant FSUIPC as the programme. I have unchecked the controllers box in P3D so assume it’s not that. I’ll send my settings over when I get home. Thanks for the quick response Ryan

I’m certain this is my fault. But I can’t find my error. I have FSUIPC6. This is the first time I’ve used it. I have very old Saitek throttles x 2. Only one works okish, so want to assign all four throttles to the one working Saitek throttle. This is for PMDG 747 P3D 4.5. so far I can only get the programme to recognise throttles 1-3. No movement from 4. This was from assigning the single throttle to control all 4. where did I go wrong? Ryan