ksnarf
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Downloads
Posts posted by ksnarf
-
-
I am using the latest version as downloaded from your website last night
here is the additional information i have found.
I used three aircraft for this test.
the Flight 1 Cessna 421c
the MS Lear
the MS Baron
all axis are programmed through FSUIPC only, including all buttons on my various control units. sensitivies have been set and verified.
I deleted all axis assignments and loaded up the Cessna 421c
I set up everything for a twin prop and flew a short patten to verify the assingments.
I then loaded up the Default lear. right away the mixture stopped working. I went into assignments and set my prop levers as reverser's. both my prop's and Mixture 1 levers worked as reverser's. I set my mixture to reverse and my props to nothing
i then took a short pattern flight in the lear to verify my settings. please keep in mind i made the changes regarding the reverser's as aircraft specific and did not change anything else
then i loaded up the default baron and used the default config which had my mixture levers as mixture and they did not move in the aircraft.
I have verified as much as a can, please help.
-kris
-
I have searched the forum with out success, so Sorry if this has already been covered.
I have used Peter's Dowson's modules for a couple years and was quite happy to support him when he made a pay version
here is the issue i am having.
if i setup all my axis (CH yoke, rudder and throttle quad) it works fine, but if i start to play with the Aircraft specific settings, my mixture controls (my quad is setup for a twin prop) stop working completly. they will be reconized when goto assign axis, but not when i try and calabrate it in the next tab.
I have tried everything with no avial. i really like the aircraft specific option, as i turn my prop levers into reverse levers for jet aircraft and it makes it alot easier.
again, no matter what i do Mixture 1 and 2 will no be seen. if i add mixture 3 and 4 to those axis, it will show up, but not 1 or 2.
thanks.
Weird issue with CH Throttle Quad
in FSUIPC Support Pete Dowson Modules
Posted
i got my drivers from this site
http://www.schiratti.com/dowson.html
I have this: FSUIPC 3.65
This is an entirely new copy of FS, because i didn't want anything i did on my old version to conflict.
I will zero out all controls again and setup for twin prop and stop the config.ini as you requested.
thanks for the help, I do appreciate it.