dajetking

Good evening I recalibrated but unfortunately the spoilers didn’t fully deploy on touchdown - didn’t move at all. They were slightly raised while in the armed position but at touchdown they never moved once the main gear touched. Also, I noticed on the upper eicas the speed brake armed message kept flashing on & off once every two seconds. It would come on for two seconds then off for two seconds. Thoughts ? Doug

Greetings. Attached is the requested log. Now that I know the spoilers deploy just a tiny bit when the speed brake handle is in the arm detent, I’m looking to see why they don’t fully deploy upon landing - they don’t move at all. I appreciate your assistance! Doug FSUIPC4.log

Copy that. That’s all need. You’ll have the file today.

Pete. The indication is on the upper Eicas of the 777. It say “speedbrakes armed”. Also, I’m not too sure how to provide the following??: “I need to see the log with those options enabled. Also please log the actual spoiler value. You do this in the Monitor facility on the right-hand side of the Logging tab: Offset 0BD0 Type U16 and check "normal log" at the bottom.” thx. Doug

One observation - in P3Dv3.4.22.19868 When I’m in the joystick calibration screen - page 6, trying to set the spoilers, I notice when I place the lever in the “armed” detent, the out number goes from -16383 to -6768 instantly. Maybe that’s causing the slight lifting of the spoilers when they are “armed”. Also, when the lever is in the armed position, at touchdown, they will not deploy - This happens when I’m either using the Sim Avionics program Or when I’m just flying P3d without the sim Avionics program on. Thx. Doug

John. I hope this is what you need from me. Thx. Doug FSUIPC4.log FSUIPC4.ini

Thx John. I’ll finally get around to sending the requested files today Doug.

Hello Pete. I’m using the jetmax throttle quadrant and P3Dv3.4 and I’m having an issue trying to get the spoilers to arm. when I place the lever in the armed position, the spoilers raise up a little bit. I did create a null zone in fsuipc but it doesn’t seem to appear in the fsuipc.ini - see attachment. This happens when I have the Sim-Avionics software on and it also happens when I don’t have the software on. any ideas or thoughts ?? Thx. Doug.