I use FSUIPC for my power controls: Power, Props, Mixture/Condition Levers. This has been bothering me for awhile, and I've never gotten over it, but I can't figure out how to improve the axis resolution while using FSUIPC. In other words, very very small adjustments are not recognized, and are input as a "step." In FSUIPC I have them sent through "Send DIRECT to FSUIPC for calibration" My current hardware is the PFC throttle quadrant with the Twin turboprop levers. The PFC is connected via USB and is recognized by windows as a joystick. I know it's not my controller because in the PFC software, it registers very tiny movements. While in FSUIPC, it shows movements in steps. Is there a setting I'm missing that can increase the resolution of inputs? Thanks for the help.