yvon

Hello Pete, Thank you for your interesting advice about sensitivity i will now test all this . Best regards, Yvon

Hello, Just wondering wether fS ( 2004 ) sensitivity has to be set to null while using fsuipc direct to fs or is that sensitivity only handled by curve response setting ? Bests regards , Yvon

Thank you , this point was important for me to know . Yvon

An additional question if you dont mind. You wrote that standard values should be Delta 256 and IN -16384 Out 16384 . In the axis assignment tab i only manage to bring the Delta value to 256 , if find it impossible to set in and out 16384 values . Are theses to be set later in joystick calibration tab ? Must i just care of Delta setting in axis assignment tab ?

Thank you, i then will set values as you say . Yvon

Hello, Yes this is now settled. Now there are à few things i still do not understand and that perhaps you would not mind explain to me . According to what i can understand reading in the manual and regarding axis assignments the delta value should be more or less 256 but what then should be in and out values , is there standards to beging with ? i think my settings are wrong , for exemple , my rudder, axis Z , has Delta 11963 , IN 0 and Out 1920 . Thank you very much for your kind help , Best regards, Yvon

"Tick the Reverse Axis box for the toe brakes and all should be well" Well this is done but i now get on the screen " differential brakes " I have assigned axis under both left and right break set , is that correct ?

Yes i have seen where it is , i am going to try this . FSUIPC seems to be marvellous for settings compared to what FS allows however i meet huge difficulties to read technical english terms , i hope i will patiently succeed :D ! Thank you very much for your kind help . Yvon

Hi, Thank you for your reply. This reverse box you refer to is to be found in which tab ? Yvon

Hello to all, I own a 3.75 registered version and i have been started to first assign axis for both josticks Saitek X52 and Ch Pro Pedals . It is ok for the x 52 ailerons and gouverne however i meet difficulties with rudder pedals for the brakes that apply permanently . The value are as follows : Left brake ( X ) Delta 256 in 16000 out 16000 Right brake ( Y ) Delta 256 in 16383 out 16383 Your help would be much appreciated to fix this very annoying dysfonctionnment . PS : I use the option send direct to FSUIPC calibration Best regards, Yvon

Hello Pete, Thank you very much for your replies. I will then download the current version and carefully read the manual included . Best regards, Yvon

Hello, I own the registered 3.74 version of FSUIPC to run with FS 2004, this is quite a long time since i am unsuccessfully trying to calibrate joysticks and especially the CH pro-pedals . The manual i hold is version 2.975 of march 2003 which is to provide the manner to do settings for FS 2000 and fs 2002 .Now i am desesperatly looking for some guide which would show how to proceed with FS 2004. I woulld really be an happy simmer to read both what to do in FSUIPC joystick tab and what to add or modify in the FS9.cfg directory , i am sure there is à lot to do . Perhaps could i find here in the forum advices and/or links that could help to solve my huge problem . Thank you very much for your interest , Best regards, Yvon