Hi Folks,
Hi Peter,
today I had a problem with programming some joystick-buttons for calling macros.
First I wrote a file called "Erwins.mcro" with the following content
[macro]
1=L:OATC=inc
2=L:TIMEC=inc
After that I edited the fsuipc.ini located in the modules folder. I filled in a new section
[MacroFiles]
1=Erwins
Inside the [buttons] section I filled in the lines:
1=P0,23,M1:1
2=P0,15,M1:2
So far so good. But it doesn't take any effect. After the restart of FSX I could see that there were comments in the fsuipc.ini as follows (or similar):
1=P0,23,M1:1 << error 19 - line ignored >>
2=P0,15,M1:2 << error 19 - line ignored >>
What I did wrong? In fact, there IS an M in both lines.
Crazy, or not????
Thanks for your help.
Best regards from Germany
Erwin