Jump to content
The simFlight Network Forums

bradrcfii

Members
  • Posts

    104
  • Joined

  • Last visited

Everything posted by bradrcfii

  1. I am using FSUIPC to calibrate my yoke. I am using the "send to FSUIPC" option. In the calibration tab, the values when turing the alerions & rudders to the left decrease. The FSUIPC manual says they shoud increase. If they do not, change the AXIS_SCALE parameter in FSX.cfg. This parameter does not exist in my cfg file. Should I, 1) Add the paramter to the FSX config file 2) User the "Rev" fucntion 3) None of the above, you have a better solution Please advise and Thanks
  2. Thanks for the responces. They were helpful and I made good progress. Programming is a little confusing at first when I relazied there are many places to assign buttons, FSX, FSUIPC and add-ons like Level D. I was able to get basic yoke functions including pitch trim and flaps working with FSX. Where I had a problem was programming the red button on the right side of the Saitek Pro Yoke. I want to assign this as an auto-pilot disconnect, "bar" on 767. Both FSX and Level-D indicates the "Z" key. After implementing, the Z key and or the red button would move the bar up or to the on position but would not disconnexct, move the bar down. Any ideas and thanks again,
  3. I have a licensed copy of FSUIPC and just purchased a Saitek Pro Yoke. I want to be sure I that I only need FSUIPC to integrate Saitek equipment and do not need to install Saitek's software. I hope that I can use FSUIPC exclusively to integrate any equipment. So my question is, do I need to use Saitek software to integrate their equipment? Thanks, Brad
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.