Jateu_01

Thank you for getting back to me. Appreciate to help.

I meant both fsuipc running as in a start up error.

Can both work at same time ? Say both MSFS and P3D fsuipc were to auto start as windows loads?

Thank you John for the prompt response

I know you have various versions of fsuipc for the different simulators but running both on one PC. Would I have to use the specific version of fsuipc for the SIM, are they interchangable etc. I would assume there would be issue using one for the other. I seem to be getting issues with hunting throttle and an appalling deadzone with yoke. I believe I have fsuipc for MSFS currently would that cause potentially conflicts with P3D? Many thanks

Pete your correct it is the idle cutoff switch when starting I need to use! I'm clearly getting confused here. Will have to have a look again. Thank you.

3590 And 3594 are the two offsets I had tried for fuel valves as per other offset list but dosent work. Apologies for not adding this to above answer Many thanks James

Sim Avionics can use user specified offsets. So if cockpit sonic use a specific offset for throttle. It can be added to a section of the software that constantly reads these offsets. As for everywhere. I meant that I have used every version of offset added to offset monitor within sim avionics and I'm getting response! But I know for fact the throttles are working. I have looked up all references of offsets and haven't found one that works. Well avionics report from the above. Will give it a go and get back toy uk both. Many thanks James

Is the cut off offset written as above or is there another hex code? Thank you Thomas. James

Hi all just need some friendly support. I have been bounced all over the place. I have converted from project magenta to sim Avionics. But I haven't changed any hardware. Most of my cockpitsonic hard ware is working apart from input from throttle quadrant. I've been searching everywhere for offsets and still incredibly frustrated. All I'm looking for is the offsets for fuel vales and throttles. Now o k ow many will ask for full details but I've tried everything and cockpit sonic still refuse to help me? Please anyone out there that can help just reply. Many thanks James

I apologie It's very frustrating. But again genuinely Thank you for fsuipc and thank you for the time and support you give.

Pete. Once again thank you for your support and fsuipc. I am now going to drop the subject and find another way around problem. Again thank you James

Cheers Pete just trying to understand what I need to do. The question is the same only because im new to this. I shall not bother you anymore. Please make sure my account is cancelled with your forum. Many thanks again

Cocpit Sonic use pm offset. I am no longer using project magenta as I have transfered across to sim avionics in order to reduce my computer count to 2 and increase my simulator speed dramatically. Everything else works apart from twork cs devices. I have managed to get most output configured it's just the switch I'm having trouble with. Us there a master offsets list? Many thanks James

Thomas unfortunately I am moving away from project magenta due to personal and technical reasons. I have looked at old pm system offsets and I can't find what I need. Hence the hunt I'm on now. Pete thank you for all your help and support with fsuipc. It is amazing. Is there any where within fsuipc that when i action a switch or button on a cockit sonic device it can register it. Again I have no support from magenta and cockpitsonic Are refusing to help. As for sim avionics they have been amazing. I fully recommend them and their software. Many thanks again to both of you. James