Pierre95

Hello, As newbie, I would like to know if it possible to set parameters and trigger FS events from a software instead from a hardware device? Thanks for help Best regards Pierre

Thanks a lot Pete. All the best Pierre

Hello Pete, Many thanks for reply. It seems FSInterrogate is usable only up to FS2004. Best regards Pierre

Hello, I would like to assign a key with 3 preset N2% for Concorde X (FSLabs) I'd like set 89%N2 at first press, 94.2%N2 at second and 82.2%N2 at third. Those settings are for deceleration descent because the AT is really to slow. I know Offset are x0896, x092E, x09C6 and x0A5E for each engine N2 and the values ares 14582, 15434 and 13468 for the settings described above. How I can do it if possible? Best regards Pierre

Ok Pete, Thanks again for all you do. Best Regards Pierre

Your hint works well...!!! Thanks. So when open subpanels like fuel management or engines starter, No event is logged as I turn switches or press button. Could tell me what can I do to capture the controls and parameters in console in this case ? Thanks by advance Pierre

Many thanks for fast reply, I'll do what you said and back... Best Regards Pierre

Hello, FSUIPC 4.xxx, and LINDA registered user, I have some newbie questions. I would like program FSLabs ConcordeX with my Yoke, Throttles quadrand (2), Rudder pedal and Vrinsight MCP Combo. I have programmed axis with FSUIPC without problem. I have programmed some Saitek devices switches with LINDA. My question is: I would like to know the parameters of the control associated with this aircraft. I had a partial answer from Linda Forum. I know the control used by ConcordeX is : 66587 for all commands So I wrote a LINDA function like this: function IAS_Acq () ipc.control(66587,71062) end function Max_Climb () ipc.control(66587,71074) end [/CODE] It allow me to press the ALT ACQ and MAX CLIMB virtual cockpit buttons through MCP Combo buttons. They work OK The problem is I don't know the parameters used by example to push down the engine1 starter. Could you tell me how find these parameter ? Hope to be clear. Thanks so much for help. Best Regards Pierre