I am attempting to program rotary controls (on the RP48) to control decision height and ND Range on a client hosted copy of PM RJ. The GF controls are connected to the server.
Using the FSUIPC button interface, I can successfully associate the rotaries with the relevant PM controls. However, there seems to a 'runaway' issue in that after an initial input (e.g. a single anti-clockwise click to reduce decision height) the control seems to be repeated and cannot be stopped by a clockwise input. Same happens with ND range - I will start at, say, 12.5 nm range and wish to increase to 25. The initial input does this, but carries on (with an interval of about 0.25 second) until maximum range is achieved.
I have ensured that the relevant Goflight rotaries do not have any conflicts in terms of Goflight managed FS controls (i.e. they are unassigned from a GF perspective), but the remaining rotaries and push buttons on the RP48 unit use (successfully) a combination of FSUIPC associations and Goflight controls.
I have not posted to the PM forum on the matter as instinct suggests I should approach this from an FSUIPC angle first.
Hope you can shed some light.
Regards
Rick Buresh