piperarrow4

Hello, Not sure if you can help, but I've had this annoying problem since I can remember flying in FS. When the autothrottle is set in cruise flight, either IAS hold or Mach hold, turning to the left and right cause the engines to speed up or slow down causing the aircraft to speed up or slow down in turns. Any ideas if FSUIPC could eliminate this problem or what might be causing this to happen?? Thanks

This may be a long shot, but I have recently installed the registered version of FSUIPC and have noticed that I have an additional process running in my task manager when fs2004 is running. The process is called ~e5d141.tmp, when I try to end the process, fs2004 shuts down immediatly. Is this process in anyway associated with FSUIPC, if not, does anyone know what it is or how to get rid of it?? It seems to be hurting my fs2004 performance. Thanks!

Thanks guys!! The problem was that out of the box the Throttle Quad. settings didn't allow for reverse past the detent, instead the bottom of reverse was set as idle. So I changed the min value for the throttles from -255 to -240 as per Bob's article and it works fine. Thank you for the support!!!

Pete, Thank you for the insight, I appreciate that. I did try to set up the reverse thrust according to the directions, but was unsuccessful, here is what I did... Section 3 in the joystick tab of FSUIPC Throttle 1 pulled all the way back and pressed the reverse set button forward of detent and pressed the idle set button Back of detend and pressed the idle set button full forward and pressed the max set button Same procedure for throttle 2 The throttle would not go into reverse, did I miss something?? Thank you for your support.

I have just purchsed FSUIPC and am getting accustome to it. I just have some quick questions... Is there a way to program a key comand to reverse the throttle axis to allow for reverse thrust to be applied with forward movement of the throttle levers? Or Is there a way to program a key command to deploy the reversers and apply throttle with forward movement of the throttles. Last question... I have read in the manual that you can assign reverser commands to the mixture control. When doing that how is the reverse activated, do you pull the mixture control back to apply reverse thrust?? Thank you!

I've been told by developers in the industry that your battery life option on the FSUIPC is available to unregistered users. Is this true, if it is, how do I access this feature? Thanks