MirageIIIEA

Hello again Pete, and thank you again for your help. I had a look at the gauge as you suggested, and I found that it indeed is a renamed copy of another freeware gauge: an older version of Lee Hetherington's ILH_TCAS, v1.1.16 I downloaded the newest version of the gauge, renamed the reference to it in the panel.cfg file, registered it with the key you provided and the error disappeared. Thanks again for your help with the problem Pete, I appreciate it! Cheers Fernando

Hello Pete Thank you for your prompt reply! I obtained this gauge as part of a freeware Concorde panel offered by the FsFrance team (http://www.fsfrance.com/Projets/Mach2/Main_eng.htm). This panel is being reworked at the moment so it's not available for download. Intrestingly, an earlier version of FSUIPC that I used to have did not give me an error message for this gauge, it's only happened with version 3.22 or 3.44. I did a search in your forum to find if this is a known problem, and I only found this one single post in which somebody is getting the same error (in his case, he states that running v3.12 did not give him the error message). If all else fails I can just try removing the gauge from this panel altogether, but if it's not too much of a headache I thought I'd try obtaining a key first. I've also written to the FsFrance team asking them if they are aware of the problem and also trying to find out who programmed it. Thanks again for your assistance Pete Best regards Fernando

Hello Mr Dowson! Thank you for taking the time to help those of us running unregistered versions of your program :) I have been experiencing the same problem with the cm_conc_tcas.gau file, and I was wondering if any progress had been made since these messages were posted. I'm currently running the unregistered version 3.22, but I've experienced the same with v3.44. Below is the error message from the log file... 3311375 Module identified = "cm_conc_TCAS.GAU" 3311375 Illegal read attempt: offset F000, size 8 3311375Program or module not accredited for use with this unregistered FSUIPC I'm currently trying to find out who programmed this gauge to ask for permission to make a FSUIPC key (if you don't mind doing it, that is :)). If you would like a copy of the gauge file I'll be happy to email it to you. Again, I don't know if the problem has been resolved already, so any information would be very helpful. Thank you very much for your time! Regards Fernando