Hello Peter,
I sent the following to Alain Capt and append below the reply.
Dear Alain Capt,
I am sorry to disturb you but ask in desperation for your help.
I had update 248 of your MD-11 panel working very well with Fs9 (version
9.0.0.30612 of the gps dlls) and FSUIPC 3.40. Everything, including the
"map vector graphic" gauge, the TCAS and the WX Radar, worked perfectly.
Then I upgraded to Fs9.1 (version 9.1.0.40901 of the gps dlls) and FSUIPC
3.44 and found that the "map vector graphics", TCAS and WX Radar no longer worked.
I uninstalled everything and then re-installed following exactly the
instructions that came with "ACSMD11panel_247.zip" and
"ACSMD11panel_U_251.zip". I used your "Install.exe" to assign the panel to my "iFDG_MD11_Alitalia" aircraft and all appeared to install correctly.
However, the "map vector graphic" gauge, TCAS and WX Radar will still not work.
Have I not followed instructions correctly? Is there something I am doing
wrong?
I would be very thankful for any help you can give.
Dear Roger,
From what you describe in your message, I see no fault you would have done.
An important information for you: versions 2.47 to 2.51 are all 100%
compatible with FS9.1. I do test all these versions. Same with the last
version of FSUIPC 3.44 which I also tested recently. So you can be sure it
SHOULD work.
From what you say, it seem that FSUIPC key auto-registration or even
probably, all communications with this module and my gauge are not working properly on your system for an unknow reason. The auto-registration with FSUIPC is in my gauge "ACS.Zulu-MD11.gau" and the key is "EHTMOBYEXWXI". On this matter, maybe you will found more informations in the file "Module\FSUIPC.log". You may also seek for help on the FSUIPC forum.
Apparently you are not the first to experience such communication problems with FSUIPC, after a FS9.1 upgrade. Maybe on this forum you will found the solution.
Keep me informed, especially if you found the solution.
Regards,
Alain Capt
On receipt of this reply, I checked everything for correct version number, deleted FSUIPC, then re-installed and re-registered it. I still get no TCAS or WX information, nor can I transfere flight plans from my FSGarmin 530 to Fs9.1 aircraft.
Can you help?