avresearch

Im not exactly sure what cured the problem, but the trim seems to function correctly now. I did install the new PFCDLL, I also changed com ports and adjusted the trim sensitivity. One of these or a combination of the above ended up solving the problem. Thanks for the help,

Im interested in knowing what kind of study you are conducting? Are you associated with the AOPA or FAA. What do you know about the capabilities of Netpipes? Im starting to run a decsion making experiment, I havent quite found the right program to record all the data I need. Thanks

First, I referred to the wrong console...im actually using the professional. I apologize for the confusion. My question now is do the numerical values under the elevator trim category (see attached) have specific settings. By this I mean, to work properly is there a single value that should go in the input value box etc. Or do the values vary with each individul setup. Thanks

im using PFC.DLL version 1.9. Better stated, my problem is that when I use the trim im not getting full travel in the simulated aircraft for example. I have been flying the Mooney Bravo and when the trim wheel on the console is at the nose up limit....the trim indicator for the airplane indicates only a small adjustment. This problem makes trimming for level flight impossible. Hope that clears up the question Thanks

Im having problems calibrating the elevator trim with MSFS '04 and my PFC cirrus console. I have made numerous attempts to fix the problem, however, I have yet to get the full elevator trim travel set right. Any help or insight into this problem would be great. Thanks