goaround

Pete got the reply and applied it and all seems good for all the throttles on the quadrant... please see below the solution that fixed it for me Here is our registry calibration guide: One way to re-calibrate your device is to reset the raw data values that are held in Windows registry. To do this: 1. Remove the USB plug for your controller from the PC. 2. Press and hold the Windows key on your keyboard and then press the letter R. This will open the Run box. 3. Type regedit and then click ok. For Windows Vista/7/8/8.1 4. The Registry Editor will have a list of folders on the left hand side. Go down into the following folders in order by clicking the + next to the folder name. + HKEY_LOCAL_MACHINE + System + CurrentControlSet + Control + Media Properties + Private Properties + Joystick + OEM 5. Delete any folder inside the Direct Input folder that begins VID_06A3 or VID_0738, if you know the specific PID number or your device then you only need to delete the string that matches the VID and PID. 6. Then navigate to the DirectInput folder + HKEY_CURRENT_USER + SYSTEM + CurrentControlSet + Control + Media Properties + Private Properties + DirectInput 7. Delete any folder inside the Direct Input folder that begins VID_06A3 or VID_0738, if you know the specific PID number or your device then you only need to delete the string that matches the VID and PID. 8. Once deleted, close the editor, then plug the USB back into the original port. Move all the axes of the controller through their full range of movement four times. This will rebuild the data range for all axes.

pete thanks for the update i will go and check the saitek forum right now. Once i have the solution from them i will post it here for future reference.

Pete, Apologies if this has already been answered but i am struggling to find the answer. I have started configuring all my controls to be via fsuipc as fsx was always losing my configuration. I have managed to configure everything as i need except throttle 4 which is on my Saitek Quadrant. The throttle seems to engage only when it is at 50% on the lever and it gives full thrust. In FSUIPC at throttle idle i have all of the levers showing the same values but once i increase the 4th throttle on the quadrant goes up to 16383 Any help would be grateful