staffguy1

when i move the saitek throttle quadrant lever down just a little the flaps lever doesnt move in fsx atleast not until im just halway down the quadrant is this a config error in a txt document or something else entirely also at some point when i move my spoiler lever back to down the lever in fsx stays up partially and until i delete the command in fsuipc it wont go back down any ideas on these two issues i am experiencing

got it fixed i deleted the file inside in the control config xml file

i did a test by just inputting my axis for the flaps and its not running the full length of the axis its cuttting out at one point then it just jumps directly to the up position or down it seems like its a config issue but i could be wrong

ok will do let me reset my controls i redid them so it would work properly

yes i did and it didnt work still having issues before the upgrade everything was working fine even in fsx:se and now fsx:se and p3d are acting up is there a input in the cfg for the control that i can delete so it can re write it and start over

it seems as if it may have todo with the new version of fsuipc it was fine with the older version is there a way to revert back

So i am now starting to move over to p3d and for some reason on my second saitek throttle quadrant in fsuipc it either goes right too 0 or right too idle unless it is the Z axis and i can not seem to figure it out any ideas. William Gliva

Every time I run the install now it doesn't pick up the fact that i have FSX:SE installed in only detects P3D i have tried reinstalling steam and i have also uninstalled FSX box version any ideas on what can be interfering with the install