Problem with offset 0BCC and 0BD0

[Fritz]

To control the speed brake in my A320 cockpit, I use an on-off switch and a potentiometer. The on-off switch is for the offset 0BCC armed position. With the potentiometer I control the offset 0BD0 with the value between –16384 to 16384.

When the potentiometer with offset 0BD0 achieved the value 4800, the FS interpreted this as the speed brake is in armed position.

That would be as i was braking and accelerating my car at the same time.

Is there any way in the FSUIPC settings to solve this problem?

regards

Fritz

[Fritz]

Problem solved.

I have assigned in the FSUIPC Spoiler Settings a value 0 - 4800 to the null zone. :D

I found out that when the offset 0BCC is set to 1, the value jumps to 0 again.

Therefore, in the position spoilers armed, the value 1 must been set for disarmed again.

regards

Fritz