Jump to content
The simFlight Network Forums

Help with Rotary

Recommended Posts

Hi Guys


I have successfully built a little control panel with Toggle Switches using a cheap board I found on ebay: This is the board http://www.ebay.co.uk/itm/2x-Zero-Delay-Arcade-USB-Encoder-PC-to-Joystick-For-2pin-Happ-Type-Push-buttons-/171137341154?pt=LH_DefaultDomain_0&hash=item27d89496e2#ht_6220wt_905

I have also bought a few Rotary Encoder 5 Pins (pushbuttons) and 1x 2P6T 2Pole 6Position 1 Deck 14P Rotary Switch w Knob

I have all my lights wired up to the Toggle Switches, works perfectly

What I would like to do now with the remaining rotarys is :

1x Rotary for Comm1 Up and Down (the switch is 360 degrees)

And the 6 Position dial to control the autobrake

I have these available ports left on the usb cards


Up Axis, Down Axis, Left Axis & Right Axis (I have 2 of these boards, so double the axis again)

and for Buttons I have 4 on each so total of 8 buttons avilable

Can someone help me figure out what I need to do?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.