Quadrant Axes Assignments Question

[AviatorMan]

Hi

 

Am making good progress on setting up with FSUIPC. Running P3Dv2.5 and have Saitek Yoke/Quadrant/Pedals. Have made buttons and axes assignments in P3D Controls and have calibrated in FSUIPC. However in the Quadrant Y and Z Axes (assigned to Engine 1 and 2 Mixture) when I pull the levers all the way back to CUTOUT, the Y Axis triggers LANDING GEAR UP/DOWN and the Z Axis triggers VIEW CHANGE. Since I have done no assignments in FSUIPC, I have checked the P3D Controls assignments for an accidental setting of these two axes in this position to LANDING GEAR and VIEW CHANGE assignments and can find nothing.

 

Any suggestions?

 

Thanks, Mike

[aua668]

Hi,

 

Check on the button page, if you have set some assignments for that switches. Pulling the Saitek levers in the cut off position acts like a joystick buttons.

 

Rgds

Reinhard