[fsuipc7 Flaps > 3 position MSFS <> Honeycomb Bravo]

Wow. Many thanks

[fsuipc7 Flaps > 3 position MSFS <> Honeycomb Bravo]

WBSIM CESSNA 172
The aircraft has three flap positions 1) FULL (fully extended) 3) 10-degree take off range 2) UP (retracted)
Those are necessary when releasing the flaps - when the button is pressed once, the flaps stop at 10 degrees and again at full. And accordingly, when cleaning, it’s the same through an intermediate stop
Now it was possible to configure only two positions up and full
And also, tell me where in the instructions or resources how to use presets how to add to FSUIP or if they already exist
However, there is no way to use the preset in the presentation, or you can assign it to the buttons
Thanks a lot, and sorry for a lot of dummy questions.

[fsuipc7 Flaps > 3 position MSFS <> Honeycomb Bravo]

Sorry again. Please help newcomers. How to set up flaps with three positions - moving up to dawn with different angles.  Fsuipc7 recognise flap as buttons in two position (up/down) 

So I would like to set, for example, up from up and stop in the middle and, after that, push down and control on the lower position and vice versa

I didn't find it in the documentation, or maybe it is very technical for me)

[Hemecomb alpha & bravo setup: constant constant roll to the left and decline]

Thank you very much. I've deleted lua script and normalised it all. Tnx.  

Sorry for of topic- with n blank profile in MSFS, how could I setup Honeycomb Bravo Throttle because any reaction in FSUIPC for trust movement

[Hemecomb alpha & bravo setup: constant constant roll to the left and decline]

Could you please help newcomer. I made  setup based  https://forum.simflight.com/topic/91617-a-step-by-step-for-fsuipc7-honeycomb-alpha-yoke-and-msfs2020/#comment-554525

In level flight, a single-engine aircraft is constantly descending (the trimmer has to be turned constantly) and often falls sharply to the left and falls.  There is no wind.  In the msfs controls settings of the honeycomb alfa everything is centered and everything works correctly

Could this setting  settings and scirpts make affect or I missed something? 

many thanks

[A step by Step for FSUIPC7, Honeycomb Alpha Yoke, and MSFS2020]

In level flight, a single-engine aircraft is constantly descending (the trimmer has to be turned constantly) and often falls sharply to the left and falls.  There is no wind.  In the settings of the steering wheel, everything is centered and everything works correctly

 Can di this after installing the FSUIPC7 settings and scripts