Elevator trim speed on PFD controls

[dfournie]

I'm using a PFC Beech Yoke/Throttle with FS2004. Is there any way to increase the speed that the electric trim switch drives the trim inside FS2004 - other than a max value in the PFC.DLL Yoke button assignment page. I've already tried that and would like it faster still. It appears the trim wheel in FS2004 runs slowly when trim up/down is initially pressed and speeds up as the trim switch is held. I guess I'm looking the trim speed to be a steady fast(er) value.

[Pete Dowson]

Is there any way to increase the speed that the electric trim switch drives the trim inside FS2004

...

I guess I'm looking the trim speed to be a steady fast(er) value.

Yes, via parameters in the PFC.INI file. Just look in the PFC.DLL User Guide, in the section on the INI file near the end. You'll see two parameters which you can change to achieve whatever you like.

Regards,

Pete