Missing Offset in the manual

[hm]

Hi Pete,

I have gone 5 times through the many pages of the offset list in "FSUIPC for Programmers" but couldn't find the test word for a full registered FSUIPC :-(. Finaly I found it in the "version history", version 3.03. It is 0x330C, bit 2^1. Would you be so kind to adapt the "FSUIPC for Programmers" manual :wink: .

Best regards

Hugo

[Pete Dowson]

I have gone 5 times through the many pages of the offset list in "FSUIPC for Programmers" but couldn't find the test word for a full registered FSUIPC :-(. Finaly I found it in the "version history", version 3.03. It is 0x330C, bit 2^1. Would you be so kind to adapt the "FSUIPC for Programmers" manual :wink:

Ooops. Sorry. Fell through the net. Actually there are a couple of other bits there which may just possibly be useful too. One of them is 2^2 which is set if FSUIPC is fully registered.

Regards,

Pete