elevatorB;rudderB;aileronB

[dazzan]

Hi Pete

Since I have copied the new FSUIPC 3.48 version over an older FSUIPC version the following axis on the copilot side do no longer work.

aileronB=66422 (Mixture1 in FS2004)

elevatorB=66425 (Mixture2 in FS2004)

rudderB=66428 (Mixture3 in FS2004)

I did not change the FSUIPC.ini file at all.

Everything is there as before.

Even when I try to calibrate the pilot joystick axes via FSUIPC 3.48, there is absolutely no change in the calibration values (even after pushing "set").

What can I do?

Thanks Pete

[Pete Dowson]

Since I have copied the new FSUIPC 3.48 version over an older FSUIPC version the following axis on the copilot side do no longer work.

aileronB=66422 (Mixture1 in FS2004)

elevatorB=66425 (Mixture2 in FS2004)

rudderB=66428 (Mixture3 in FS2004)

I did not change the FSUIPC.ini file at all.

Everything is there as before.

Even when I try to calibrate the pilot joystick axes via FSUIPC 3.48, there is absolutely no change in the calibration values (even after pushing "set").

What can I do?

Hmmm. I've not made any changes recently to anything that might affect that. Can you tell me the version number of the last version you used with this working, please? I may have inadvertently messed it up, but I need to know when it may have been to narrow it down.

Please attach your FSUIPC.INI file too (in text form if you like

Thanks

Pete

[dazzan]

Hi Pete,

The only version of FSUIPC I found back was version 3.4.1.1

Everything was OK there for:

aileronB=66422

elevatorB=66425

rudderB=66428

I noticed also that fsuipc 3.48 takes the same axis for reverser 1 to 3.

I changed the values to 0, but the B axis were still not working.

Thanks

[Pete Dowson]

The only version of FSUIPC I found back was version 3.4.1.1

Everything was OK there for:

aileronB=66422

elevatorB=66425

rudderB=66428

There's been a lot of changes since 3.411. This may take some finding. Leave it with me for now -- I'll get back to you if I need more information.

I noticed also that fsuipc 3.48 takes the same axis for reverser 1 to 3.

I changed the values to 0, but the B axis were still not working.

The separate reverser assignments are not relevant unless you go to the last page and set them.

Regards,

Pete

[dazzan]

Hi Pete

Version 3.45 did already not work

[Pete Dowson]

Version 3.45 did already not work

Well, that narrows the change in which the error occurred a little. Thanks. I should get to it next week. Sorry about the delay.

Pete

[Pete Dowson]

I think I found a bug which could have made these co-pilot controls not work. I haven't time to test the fix here till later this week, and it will take a bit of setting up to get the extra inputs, so I wondered if you would like to try it with your configuration and let me know, please.

The fix is in the attached test version 3.481.

Regards,

Pete

FSUIPC3481test.zip