PFC yoke button and SB3/CH throt. quad reverse

[Angelo Cosma]

I need to know ho to make the top part of my rocker switch on my PFC yoke to trigger the mic so I can talk to a controller in SB3 your help is appreciated.

Also I would like to use my ch throttle quad. for reverse thrust for 2 engines i did the calibration in fsuipc but the revesers un become unlocked and DONT fully reverse and theres no more room to pull the lever back and i dont want to use a seperate lever for this thanks for your HELP.

[Pete Dowson]

I need to know ho to make the top part of my rocker switch on my PFC yoke to trigger the mic so I can talk to a controller in SB3 your help is appreciated.

Please see the PFC DLL documentation! In the section entitled Button Assignments (in PFC options) you'll find it listed in the table as "PTT Roger Wilco (local)". For SB3 running on a WideFS client use the one below that instead, and edit the WideClient INI file to suit, as described in the WideFS documentation.

Also I would like to use my ch throttle quad. for reverse thrust for 2 engines i did the calibration in fsuipc but the revesers un become unlocked and DONT fully reverse and theres no more room to pull the lever back and i dont want to use a seperate lever for this thanks for your HELP.

What does "unlocked" mean in this context?

If you cannot achieve full reverse then you have not calibrated correctly. Always leave a little bit of slack at BOTH ends of the lever movement when clicking the buttons in FSUIPC to tell it where the minimum and maximum points are -- all these devices are subject to variation (heat, humidity, physical variations), and if you don't "waste" a little of the movement at the extremes the minimum and maximum values you achieve will vary every time.

Regards,

Pete