Driving Spot plane view using FSUIPC

[bigskyfunk]

Pete,

I am using FSUIPC to pass the attitude and position from my own 6doff simulation to FS9. This works fine, but when I try to use the "Spot Plane" view, it stutters and stays in the original position.

Can I drive the "Spot Plane" view from FSUIPC?

What I want to do is fly on one computer with the cockpit view and use wideview to display the spot plane view, but it is a "stationary stutter" as well. For my application, I dont use any Insturments except for Wideview.

Do you have any thoughts or suggestions?

Thanks for your time.

[Pete Dowson]

Can I drive the "Spot Plane" view from FSUIPC?

I don't think so.

What I want to do is fly on one computer with the cockpit view and use wideview to display the spot plane view, but it is a "stationary stutter" as well. For my application, I dont use any Insturments except for Wideview.

I'm sorry, but I don't know enough about WidevieW to advise. I'm not sure where it gets "spot plane" information from. You need to go to the WidevieW support site.

Regards,

Pete